Strong data processing capacity, visual operation, easy to learn, can be used offline, almost meet all customer processing requirements.
Ranging from 60W 80W 100W 130W to 150W, more powers provide by famous brand, , giving customers more choices.
Suitable for advertising, printing, craft gifts, models and other large format requirements of the machine.
Taiwan famous brand guide rail to ensure high precision processing
The thickening belt can minimize belt tension and deformation, so that the accuracy of the work is not affected.
If there is no water to cool the tube, the machine automatically recognizes that it stops working and prevents damage to the laser tube caused by no cooling.
This design of voiern makes it easier to clean the debris generated during processing.
|Engraving thickness||2mm(depends on material)|
|Cutting thickness||2cm(depends on material)|
|Laser type||sealed CO2 laser tube|
|Cooling mode||water cooling protection system|
|Positioning way||red light positioning|
|Working platform||Blade platform|
|Power supply||AC220V/110V 50HZ|
|Package||Standard plywood case|
|Control software||Coreldraw/RUIDA V8|
1. Connect computer to machine with date lines but it does not work
A. Check the date lines , do not use long date lines .
B.Check the USB port . It works or not
C. Check the date line and Softdog . make sure they all are plugged into computer
2. Engraving depth is not uniform
A. Close the machine and after 1 hour start it check if there is water in water pipe.
B. Check the light path , and adjust it( refer to vedio of adjusting light )
3. Turn on the switch of machine , but is does not work
A.Check the power lines .it is connecting or not .
B. Check the scram button , make sure it is closed
4. The engraving thikness is small
A. Adjust the light path to make sure the light is at the center
B. Check the lens. and make sure they are clean
5.Engraving blurred image
A:Put the focusing mirror back or wrong focusing length.You should square the lens. Adjust to the specified
6. Machine has spark
A:Poor electrical contact, or the air is too damp.You should connect the wire, clean the dust, keep air ventilate
7.Engraving dislocation or stop engraving
A:Electrostatic interference with the motherboard or signal transmission error.You should install and check the
ground wire, update the data cable or change the computer.
8.The laser head not has light
There are 4 points to be check:
(1)Check electric current.Press“TEST”button on machine screen board.If there is not electric current showed on
screen board,you should try to make sure all wiresare connected well.If there is electric current showed on
screen board,maybe the lens is broken,laser tube light exit and lens are contaminated.Or the light path offset.
(2)Check water cycle .If there is not water cycle,maybe the water pump damage.If there is water cycle,please
check whether the inlet and outlet are connected in reverse,or pipe fractures.
(3)If a dot emit light.If there is not a light,please check the wire between the engraving machine control board
and the power supply is in good contact.
(4)If above is no problem,maybe machine power damages,you should repair it.